Skip to content
Maxisil Applicator

Maxisil Applicator

by MAXISIL
SKU RDXA3000
$5.50 - $5.50
$5.50
$5.50 - $5.50
$5.50
<p>Earn%20[points_amount]%20when%20completing%20this%20purchase.</p>

A smooth, controlled caulking gun built for Maxisil cartridges. The Maxisil Applicator dispenses 310ml silicone and adhesive tubes with even, controllable pressure for a consistent bead and clean start-stops — and a smart thrust design means less waste and less hand fatigue over a long day of joints.

More Details

The Maxisil Applicator is a caulking gun for dispensing Maxisil 310ml cartridges. Details:

  • Purpose: Dispenses 310ml Maxisil silicone and adhesive cartridges
  • Control: Even, controllable pressure for a consistent bead and clean start-stops
  • Benefit: Reduces waste and hand fatigue on long runs
  • Use with: The full Maxisil 310ml silicone and adhesive range
Shipping & Return Policies

Shipping Policy

Refund & Return Policy

Maxisil Applicator — Smooth, Controlled Beads From the First Pull

A bad caulking gun ruins good silicone. Juddery pressure lays a lumpy bead, a gun that keeps pushing after you release drips silicone everywhere, and a stiff trigger wears out your hand halfway through a bathroom. The Maxisil Applicator is built to dispense Maxisil cartridges the way they deserve — smooth and controlled.

Even, controllable pressure gives you a consistent bead and clean start-stops, and the thrust design cuts down on waste and the hand fatigue that comes with a full day of joints. It's made for the 310ml Maxisil range, so it pairs perfectly with your Maxisil silicone and MaxiGrab adhesive.

Why Tile Pros Choose It

  • Consistent bead: Even, controllable pressure
  • Clean start-stops: Less drip when you release
  • Less fatigue: Easier on your hand over long runs
  • Less waste: Smart thrust design
  • Made for Maxisil: Fits the 310ml cartridge range
  • The gun that lets the silicone look good: Half the finish is the delivery

Pro tip: Release the trigger a moment before you reach the end of a run and let the bead taper off, so you don't over-apply and have to clean up a blob at every stop.